Problem with remote connecting the GC6890 to Chemstation

Discussions about GC and other "gas phase" separation techniques.

2 posts Page 1 of 1
Hi All,

I am new to this wonderful forum. I have a question. I have a GC-6890N system. I have also installed Chemstation on my PC. In the configuration editor it asks for type of the GC, which I have selected 6890 GC [6890 GC (classic) is also available]. I then inserted the IP address of my machine ( The port address is listed as 9100, by default. Then I save the machine and start the online software. However, when the software is initializing, when it reaches to the instrument (in the loading), it gives me an error saying:

"Attempt to connect to the configuration from Agilent 6890 GC ( failed. Please make sure that your device is connected and push retry. .."

Any suggestion? Have I made a wrong move?

2 posts Page 1 of 1

Who is online

In total there are 16 users online :: 2 registered, 0 hidden and 14 guests (based on users active over the past 5 minutes)
Most users ever online was 209 on Wed Nov 29, 2017 10:42 am

Users browsing this forum: Bing [Bot], mbdixon and 14 guests